Talk · Purchasing · Samples, tooling & launch

What retail box size fits a standard peg hook or hang-tab display?

There is no single box size for peg displays, because hooks, hole sizes and shelf spacing vary by retailer.

Wecent Editorial Team Updated 25 Oct 2026 3 min read

The question

A retailer wants our charger on a peg hook display. What box size and hang-tab design will work, and what should we check before printing?

Main answer · Wecent Editorial Team

Short answer: There is no single box size for peg displays, because hooks, hole sizes and shelf spacing vary by retailer. The reliable approach is to ask the retailer for its planogram and hang-tab specification, then design the box so that its weight is balanced under the hole and the print leaves the tab area clear. Send a physical dummy for approval before printing.

Start with the retailer’s specification

Retail chains publish packaging guidelines, and many give a hang-tab size, hole shape, peg diameter and maximum package weight. Ask for these, and for the shelf or planogram space allowed for your product. Never assume a standard.

What to settle

Hole shape and size. Round, slotted or euro holes suit different pegs. The retailer states which.
Position. The hole should sit near the top centre so the box hangs straight.
Reinforcement. A hole in thin board can tear under the weight of a charger. A reinforced tab or a thicker board prevents this.
Weight and balance. A heavy charger at the bottom pulls the box forward. Position the product in the box so that it hangs straight.
Box depth. A deep box takes more peg length and may block the next product.

Printing considerations

Keep the area around the hole free of text and logos. A hole punched through a barcode or a safety mark makes the box unreadable. Check that the barcode and compliance marks remain visible and unobstructed when hanging.

Test before printing

Make a white dummy box with the hang-tab and a dummy charger of the right weight.
Hang it on the retailer’s type of peg, or a similar one.
Check that it hangs straight and the product does not slide.
Shake lightly and check for tearing.
Photograph and send to the retailer for approval.

Alternatives

Some retailers prefer shelf-ready cartons or clip strips. If you plan both, design the box so that it works either way.

Keep a file

Record the retailer’s specification, the approved dummy and the final artwork together. It speeds up the next listing and avoids reprinting.

Plan for reorders

Retailers sometimes change shelf fixtures between seasons. Keep the dummy and the specification on file, and ask your buyer to tell you before a display refresh. A box that fitted last year may need a new tab if the peg type changes, and finding out early avoids a rushed reprint.

Where this answer says to confirm with Wecent, the detail is not published on the product page and has to come from the datasheet or the factory. General facts come from the regulators, standards bodies or device makers named in the text.

Three more perspectives

Wecent Editorial Team · Purchasing perspective

Ask the retailer for the planogram early and print nothing until the dummy is approved. Reprinting a box is a far bigger cost than a week’s delay.

Wecent Editorial Team · Compliance/QC perspective

Check that required markings, barcodes and warnings stay clear of the hole and the fold lines.

Wecent Editorial Team · After-sales perspective

Note retailer feedback on displays and returns. A box that tears or hangs crooked will be noticed in store.